APC UTS6BI Guía de instalación descargar pdf (Pagina 17)

Site Preparation & Installation Guide Universal Transfer Switch UTS6 UTS6H UTS6BI UTS10BI16

UTS Controls and Indicators

The UTS controls and indicators are located on the front of the UTS.

Control or Indicator Description

1 LCD • Displays two lines with 20 characters per line

• Displays UTS status, warnings, general information

• Displays the value or setting that is being entered or changed during

configuration and setup

2 System Status button Cycles the UTS through the default or selected system status options

3 System Setup button Used to configure the UTS system options

4 Circuit Status button Cycles the UTS through the circuits displaying the status of each on the LCD

5 Circuit Setup button Used to configure the UTS individual circuit options

6 Down/Up arrow buttons Used to scroll through steps for configuration and to scroll between status and

informational displays

7 Source LEDs

Utility

Generator

UPS

• Solid green LED illumination indicates that the power source is ON and is

functioning normally

• No LED illumination indicates that the power source is OFF or is outside

specified limits

• A flashing green LED indicates that a fault condition exists for that power

source, and should be corrected

8 Circuit LEDs The number of circuit LEDs varies dependent on the model of UTS

• Red LED illumination indicates that the UTS circuit is receiving power from

one of the power sources

• No illumination indicates that circuit is receiving no power

• A flashing red LED indicates that a fault condition exists and should be

corrected

bu163a

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Sin comentarios

APC UTS6BI Guía de instalación Pagina 17