APC NBWL0456 Guía de instalación descargar pdf (Pagina 20)

NetBotz Wireless Sensor Pod 180 Installation Guide

Updating the Wireless Sensor Pod

Firmware updates for the Wireless Sensor Pod are included in the Botzware

firmware releases. When a Botzware firmware update is available, you

download it from www.apc.com

and install it on the NetBotz appliance.

The Wireless Sensor Pod configured as the Coordinator receives the firmware

update package from the NetBotz appliance over the USB connection. The

Wireless Sensor Pods configured as Routers or End Devices receive the update

package from the Coordinator using the standard Zigbee update protocol.

Note: Wireless Sensor Pod communications are ignored while the

host appliance is transferring the firmware update package to the

Coordinator. No sensor data is sent from the Coordinator to the

host appliance during this time.

Once the Botzware firmware update is applied to all the sensor pods on the

wireless network, the Firmware Update Available button is activated in the

Wireless Sensor Setup task in the Advanced View.

When you click the Firmware Update Available button, the Coordinator

communicates with all the sensor pods on the wireless network to update the

firmware. After 12 -15 minutes, all the sensor pods will reboot to finalize the

firmware update.

Cleaning the Wireless Sensor Pod

To clean the device, gently wipe surfaces with a clean, dry cloth.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Sin comentarios

APC NBWL0456 Guía de instalación Pagina 20