APC RAID Subsystem SCSI-SATA II Manual de usuario Pagina 24

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 105
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 23
- 23 -
3.2 How to use the system quickly
The following methods will describe the quick guide to use this controller.
3.2.1 Quick installation
It is easy to use “Quick install” to create a volume. It uses whole physical disks to
create a RG; the system will calculate maximum spaces on RAID levels 0 / 1 / 3 / 5 /
6 / 0+1. “Quick install” will occupy all residual RG space for one VD, and it has no
space for snapshot and spare. If snapshot is needed, please create volumes by
manual, and refer to section 5.4 for more detail. If some physical disks are used in
other RGs, “Quick install” can not be run because the operation is valid only when
all physical disks in this system are free.
Step 1: Click “Quick install”, then choose the RAID level. After choosing the RAID
level, then click “Confirm”. It will link to another page.
Figure 3.2.1.1
Step 2: Confirm page. Click “Confirm” if all setups are correct. Then a VD will be
created.
Step 3: Done. You can start to use the system now.
Figure 3.2.1.2
(Figure 3.2.1.2: A virtual disk of RAID 0 is created and is named by system itself.)
RAG362
Vista de pagina 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 104 105

Comentarios a estos manuales

Sin comentarios