APC NBRK0570 Especificaciones descargar pdf (Pagina 9)

3NetBotz Rack Monitor 450/550/570 Installation and Quick Configuration Manual



10/100 Base-T Network

Port

Provides for a 10/100 Base-T network connection. Status and link LEDs indicate network

traffic:

• Status LED—blinks orange and green at start-up; indicates the status of the network

connection (solid green—IP address established; blinking green—attempting to obtain

an IP address).

• Link LED—blinks to indicate network traffic (green—connected at 10 Mbps; orange—

connected at 100 Mbps).



Alert LED Indicates the alert status of the system. When more than one alert exists, the most severe

will be indicated.

• Flashing once every eight seconds—Informational

• Flashing once every four seconds—Warning

• Flashing once every two seconds—Error

• Flashing once every second—Critical

• Flashing twice per second—Failure



Voltage Output Provides 12 VDC or 24 VDC (75 mA) to one connected device.

Relay Output Ports 1, 2 Used for connecting relay-controlled external devices. Provides 24 VDC (100mA) each.



Power LED Indicates whether the unit is receiving power (green—receiving power; dark—not

receiving power).



4-20 mA Inputs Provides 24 VDC for connecting third-party sensors with an input current range from 4 to

20 mA.



Sensor ports Used for connecting APC sensors, third-party dry-contact sensors, and standard third-

party 0-5 V sensors. (See “Additional Options” on page 1 for details on APC sensor

options.) Third-party dry-contact state sensors require the NetBotz Dry Contact Cable

(NBES0304). Standard third-party 0-5 V sensors require the NetBotz 0-5 V Sensor Cable

(NBES0305). NBRK0450/550 - 5/24 VDC (50mA). NBRK0570 - 5/24 VDC (200mA).



Leak Rope port Used for connecting a NetBotz Rope Leak Sensor (NBES0308)



Beacon port Used for connecting an Alarm Beacon (AP9324).

A-Link port Used for cascading NetBotz sensor pods and temperature and humidity sensors with

digital displays. Provides communications and power to the connected devices over

standard CAT-5 cabling with straight-through wiring. For details, see “Connect Sensors

and Sensor Pods to A-Link Ports” on page 10.

Alert LED Same as item 4 above.

Power LED Indicates whether the unit is receiving power (green—receiving power;

dark—not receiving power).

Console Port Used to connect a console to the appliance. Enable the USB-to-serial converter support

(FTDI) in your operating system.

USB Type A ports

(2 or 4)

Used to connect USB devices to the appliance. The NBRK0550 and NBRK0450 have

two USB ports, while the NBRK0570 has four.

Exhaust fan Exhausts hot air from the NBRK0570. Not present on the NBRK550 or NBRK450.

Item Description

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Comentarios a estos manuales

Sin comentarios

APC NBRK0570 Especificaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad APC NBRK0570