APC AP9613 Manual de instalación descargar pdf (Pagina 14)

Installation Manual

Device IP Configuration Utility

The Device IP Configuration Utility can discover Network Management Cards

(NMC) that do not have an IP address assigned. Once discovered, you can configure

the IP address settings for the cards.

You can also search for devices already on the network by entering an IP range to

define the search. The Utility scans the IP addresses in the defined range and

discovers cards that already have a DHCP-assigned IP address.

For detailed information on the Utility, see the Knowledge Base on the

support page of the

www.apc.com website and search for FA156064

(the ID of the relevant article). To use the DHCP Option 12 (AOS 5.1.5

or higher), see Knowledge Base ID FA156110.

System requirements. The Utility runs on Microsoft Windows 2000, Windows

Server

2003, Windows Server 2012 and on both 32- and 64-bit versions of

Windows XP, Windows Vista, Windows 2008, Windows 7 and Windows 8

operating systems.

This utility supports cards that have firmware version 3.0.x or higher and is for IPv4

only.

Installation. To install the Utility from the Utility CD:

1. If autorun is enabled, the user interface of the CD starts when you insert the

CD. Otherwise, open the file

contents.htm on the CD.

2. Click

Device IP Configuration Utility and follow the instructions.

To install the Utility from a downloaded executable file:

1. Go to

www.apc.com/tools/download.

2. Download the Device IP Configuration Utility.

3. Run the executable file in the folder to which you downloaded it.

When installed, the Utility is available through the Windows menu options.

DHCP and BOOTP configuration

The default TCP/IP configuration setting, DHCP, assumes that a properly

configured DHCP server is available to provide TCP/IP settings to Network

Management Cards. You can also configure the setting for BOOTP.

A user configuration (.ini) file can function as a BOOTP or DHCP boot

file. For more information, see the TCP/IP configuration section of the

Network Management Card User’s Guide, available from the Utility CD

or the APC Web site, www.apc.com.

DMP IM 990-3404.book Page 10 Monday, March 11, 2013 9:05 AM

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Sin comentarios

APC AP9613 Manual de instalación Pagina 14