APC RAID Subsystem SCSI-SATA II Especificaciones descargar pdf (Pagina 36)

To access drive bays on the left- or right-side column, first flip the retention latches (see

Error! Reference source not found.) on the enclosure front handles, and then swing the

handles to the left and right-hand sides. To close the handles, see Figure 2-7, first swing

the handles towards the center to reveal the retention latch, flip the latch, and then

proceed with closing the handles.

Figure 2-7: Closing the front handles

Install the drive trays into the subsystem once the hard drives have been installed in the

drive trays.

Step 1. Make sure the key-lock is in the unlocked position, i.e., the groove

on its face is in a horizontal orientation. If the groove is in a vertical

position, as shown in Figure 2-8, then the key-lock is locked and the

front flap on the drive tray cannot be opened.

Clip

Figure 2-8: Front View of an Individual Drive Tray

Step 2. Open the front flap on the drive tray (See Figure 2-9) by pushing the

release button (shown in Figure 2-8) on the front of the drive tray.

The button is easy to access and lift.

2-12

Drive Tray Installation

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 99 100

Sin comentarios

APC RAID Subsystem SCSI-SATA II Especificaciones Pagina 36