APC MGE Galaxy 300 Guía de usuario descargar pdf (Pagina 95)

86Network Management Card User’s Guide

Use FTP or SCP to upgrade multiple Management Cards. To upgrade multiple Network

Management Cards using an FTP client or using SCP, write a script which automatically performs the

procedure.

Using the NMC2 Firmware Upgrade Utility for multiple upgrades

After downloading from the American Power Conversion website, double click on the exe file to run the

utility (which ONLY works with IPv4) and follow these steps to upgrade your firmware:

1. Type in an IP address, a user name, and a password, and choose the Ping button if you need to

verify an IP address.

2. Choose the Device List button to open the

iplist.txt file. This should list any device IP,

user name, and password, for example,

SystemIP=192.168.0.1

SystemUserName=apc

SystemPassword=apc

The new utility works fine with any existing

iplist.txt file that you have used with the

old version of the utility.

3. Select the Upgrade From Device List check box to use the

iplist.txt file. Clear this check

box to upgrade the firmware using the IP, user name and password you typed on the dialog box.

4. Choose the Upgrade Now button to start the firmware version update(s).

Choose View Log to verify any upgrade.

Use XMODEM to upgrade one Management Card

To use XMODEM to upgrade one Management Card that is not on the network, you must extract the

firmware files from the firmware upgrade tool (see “To extract the firmware files:” on page 84).

To transfer the files:

1. Select a serial port at the local computer and disable any service that uses the port.

2. Connect the provided serial configuration cable (part number 940-0299) to the selected port and

to the serial port at the Management Card.

3. Run a terminal program such as HyperTerminal, and configure the selected port for 57600 bps, 8

data bits, no parity, 1 stop bit, and no flow control.

4. Press the Reset button on the Management Card, then immediately press the

ENTER key twice, or

until the Boot Monitor prompt displays:

BM>

5. Type XMODEM, then press ENTER.

6. From the terminal program’s menu, select XMODEM, then select the binary AOS firmware file

to transfer using XMODEM. After the XMODEM transfer is complete, the Boot Monitor prompt

returns.

7. To install the application module, repeat step 5 and step 6. In step 6, use the application module

file name.

8. Type

reset or press the Reset button to restart the Management Card.

For information about the format used for firmware modules, see “Firmware files

(Network Management Card)” on page 83.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 104 105

Comentarios a estos manuales

Sin comentarios

APC MGE Galaxy 300 Guía de usuario Pagina 95

Comentarios a estos manuales

Relacionado con productos y manuales para Software APC MGE Galaxy 300