APC RAID Subsystem SCSI-SATA II Manual de usuario descargar pdf (Pagina 106)

SAS / SATA II NAS System

106

User’s Manual

8.1.1 Volume Group Management

Volume Group (VG) is created by joining at least one disk, which can be physical disk or

RAID disk(s). Logical Volumes are created under the Volume Group.

proNASVG is the system default VG. It must be created first in order to use the NAS

system. To create the proNASVG, it is necessary to join at least one “New” or

“Non_Initialized” disk into proNASVG.

Admin can create other VG by joining other new or “Non_Initialized” disk, create or

remove LV in this VG, join any new disk, remove any disk and reset the VG.

NOTE: If the Disk List in Volume Manager does not show any RAID

disk (for example: /dev/sda) but a Raid Set and Volume Set has

been created already, it is necessary to restart the proNAS system.

Go to System Manager, select Reboot tab, and click Reboot Now

button. Then re-login to NAS administration page.

8.1.1.1 Create the proNASVG Volume Group

To create the proNASVG, perform the following steps:

1. In the proFamily tree, select Volume Manager. Verify that the Disk List shows at

least one disk and the Status is “Non_Initialized’. Noticed in the Volume Group

List that the proNASVG has no Disk List.

NOTE: The system default Volume Group “proNASVG” cannot be

deleted or reset.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 258 259

Sin comentarios

APC RAID Subsystem SCSI-SATA II Manual de usuario Pagina 106