APC Network Management Card AP9617 Guía de usuario descargar pdf (Pagina 46)

®®

USER’S GUIDE

network management card

Boot mode setting. This setting selects which method will be used to

define the Management Card’s TCP/IP settings whenever the Management

Card turns on, resets, or reboots:

• DHCP & BOOTP: The Management Card will attempt to get its TCP/IP

settings from a BOOTP server, first, and then, if it cannot discover a

BOOTP server, from a DHCP server.

• DHCP only: A DHCP server provides the TCP/IP settings.

• BOOTP only: A BOOTP server provides the TCP/IP settings.

• Manual: Three settings (System IP, Subnet Mask, and Default

Gateway) which are only available when Manual are used to define

the needed TCP/IP settings.

An After IP Assignment setting will, by default, switch Boot

mode from its default DHCP & BOOTP setting to BOOTP

only or DHCP only, depending on the type of server that

supplied the TCP/IP settings to the Management Card. For

information about the After IP Assignment setting, and

other settings that affect how the Management Card uses

BOOTP and DHCP, see Advanced settings; For more

information about how to use DHCP, see Boot Mode; for

more information about how to use BOOTP, see the

Management Card Addendum provided on the APC Network

Management Card utility CD (./doc/adendum.pdf).

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 149 150

Sin comentarios

APC Network Management Card AP9617 Guía de usuario Pagina 46