
®
®®
®
USER’S GUIDE
network management card
77
Reset UPS Defaults
This option allows you to reset the UPS to use the default EEPROM values.
Configure the Multiple/Parallel UPS IP Address and
Monitor Name (Silcon UPS only)
This option is only available in the Web interface. It allows you to identify up
to nine different Silcon UPS models which you can then access through the
View the refreshing status page hyperlink that appears in the “Status for
UPS” page.
Caution
Before you use this option, make sure that resetting the
EEPROM values will not adversely affect the load equipment or
any shutdown sequence.
Setting Definition
IP Address
Identifies the Silcon UPS to be monitored by the
IP address of
its Management Card.
Monitor Name Identifies the name of the Silcon UPS to be monitored.
Comentarios a estos manuales