APC Network Management Card AP9617 Guía de usuario descargar pdf (Pagina 76)

®®

USER’S GUIDE

network management card

UPS Control

The options described in the following table are available to all UPS

models, except the Silcon UPS.

By default, no control options are available for Silcon UPS until you enable

the Accept Remote Turn Off Commands option (disabled by default) in

the control console’s UPS Control menu.

The Accept Remote Turn Off Commands option appears only in the

control console’s UPS Control menu, and then only when you use a local,

serial connection to access the control console (see Local access to the

control console). When Accept Remote Turn Off Commands is enabled:

• Two control options, Turn UPS Off and Turn UPS Off Gracefully

options, become available for a Silcon UPS

• A Disable Remote Turn Off Commands option appears in the UPS

Control menu at the Web interface and control console, allowing you

to disable using the Management Card to turn off the Silcon UPS

For descriptions of the Self-Test, Simulate Power Failure,

Start/Stop Runtime Calibration, and Test UPS Alarm

options, see Diagnostics.

Action Definition

Turn UPS On

(control console)

Turns on power at the

UPS.

Turn UPS Off

Turns off power, after the Shutdown Delay, until you turn on

power again.

1 The Web interface has a Signal servers option. When Yes is selected for that option,

initiating a Turn UPS Off, Reboot UPS, or Put UPS To Sleep action is equivalent to selecting

the Turn UPS Off Gracefully, Reboot UPS Gracefully, or Put UPS To Sleep Gracefully

options which are available in the control console.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 149 150

Sin comentarios

APC Network Management Card AP9617 Guía de usuario Pagina 76