APC IP DSLAM Guía de usuario descargar pdf (Pagina 248)

240

(Not available for ADSL)

Chan Perf BE

The near-end idle bit error count performance

parameter is a count of the number of bit errors

in the idle cell payload received in the ATM Data

Path at the near-end. (Not available for ADSL)

PM State

The Line Power Management state. (Not

available for ADSL)

Chan Perf Cu

The total number of data-only cells received by

ATUC.

Extended PSD Status

Conexant parameter that indicates whether an

extended upstream PSD is used - for G.Span

Plus mode of operation only. Only supported for

G.Span Plus, therefore this parameter is not

valid for ADSL2/ADSL2plus modes of operation.

Chip Version

The DSP version number.

Pilot Tone

Conexant parameter that indicates the Pilot

Tone Index.

Overhead Channel

Indicates the Overhead Channel. This feature is

not supported by DSLPHY as yet.

Psd Mask

Conexant parameter that indicates the actual

Psd Mask currently being used.

System Vendor ID

Indicates the Vendor ID as inserted by the ATU-

C in the Overhead Messages(ADSL2). Typically

identifies the ATU-C system integrator which

usually refers to the vendor of the smallest field-

replaceable unit. ATU-C System Vendor ID may

not be the same as ATU-C Vendor ID. It is not

available for ADSL. This is string of 8 octets

containing 2 octet country code , 4 octet vendor

id and 2 octet vendor revision number.

ATU-C Self Test Result

Defines the ATU-C selftest result. The most

significant octet is: 00 hex if the self-test passed

or 01 hex if the self-test failed. Interpretation of

the other octets is vendor discretionary and can

be interpreted in combination with G.994.1 and

system Vendor IDs.

Atuc G9941 Vendor ID

Indicates the Vendor ID as inserted by the ATU-

C in the G.994.1 CL message. Typically

identifies the vendor of the ATU-C G.994.1

functionality. This is string of 8 octets containing

2 octet country code , 4 octet vendor id and 2

octet vendor revision number.

Atuc ACTPSDus

(dB/10)

This parameter defines the average upstream

transmit power spectrum density over the used

subcarriers delivered by the ATU-C at the U-C

reference point, at the instant of measurement.

It's value ranges from -90 to 0, in 0.1 dB/Hz

steps. It is available only for ADSL2/ADSL2plus.

AtucStartBin

(GSpan++)

This Gspan++ parameter indicates the start bin

of the bit loading up array.

StartUp Error Code

Conexant parameter which indicates the startup

error code.

BitSwapCount

This Conexant parameter indicates the bit swap

count. It can read only in data mode

ModPhase

Conexant parameter to monitor the status of

MoD

Atuc TSSpsUs

This parameter provides the Upstream Transmit

Spectrum Shaping parameter expressed as the

set of break points exchanged during G994.1.

Each breakpoint consists in a subcarrier index

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 602 603

Comentarios a estos manuales

Sin comentarios

APC IP DSLAM Guía de usuario Pagina 248

Comentarios a estos manuales

Relacionado con productos y manuales para Redes APC IP DSLAM