APC IP DSLAM Guía de usuario descargar pdf (Pagina 448)

100

101

440

Valid values: 0- 0xffffffff

Default value: 0

routingstatus enable

|disable

This specifies if the IP Routing Lookup has to be

done for this interface. By default, for the

downstream traffic destined for IPOE interface, IP

lookup is done based on the downstream route

configured for the IPOE interface.If iproutingstatus

is disabled, layer 2 lookup shall be used instead,

for forwarding the downstream traffic for this IPOE

interface.

Type: Create － Optional

Modify － Optional

Default value:enable

enable|disable

Administrative Status of the interface.

Type: Optional

Valid values: enable or disable

Example

$ create ipoe intf ifname Ipoe-0 lowif Ipoa-0 macaddrprof 1 ethpkttype

Type2 inactivitytmrintrvl 10 routingstatus disable cfgmode Auto enable

Output

Verbose Mode On

Entry Created

Ifname : Ipoe-0 Low If Name : Ipoa-0

Mac Addr Prof : 1 Eth Pkt Type : Type2

InActivity Tmr Interval : 10

RoutingStatus : disable

Oper Status : Up Admin Status : Enable

Verbose Mode Off:

Entry Created

Output Fields

FIELD Description

Ifname

The IPOE Tunneling Interface.

Low If Name

This specifies the lower interface index.It

contains the ifindex of the IPoA interface.

Mac Addr Prof

Profile Id corresponding to the MAC address

assigned to this IPOE interface. This Profile is

created using the MacAddrProfileTable.

Eth Pkt Type

This specifies the type of the Packet.

InActivity Tmr Interval

This field specifies the time (in seconds) after

which interfaces shall be marked inactive, if

there is no data activity on this interface during

this interval. This is used only when the bit

corresponding to "ConfigEntry" is set for

gsvIpoeConfigStatus field. A value of zero

means the timer is not running. In autosensing

scenario, an inactive interface is a candidate to

deletion, if another protocol is sensed on Atm Vc

Interface on which this interface is created

RoutingStatus

This specifies if the IP Routing Lookup has to be

done for this interface. By default, for the

downstream traffic destined for IPOE interface,

IP lookup is done based on the downstream

route configured for the IPOE interface.If

iproutingstatus is disabled, layer 2 lookup shall

be used instead, for forwarding the downstream

traffic for this IPOE interface.

Admin Status

Administrative status of the interface.

Oper Status

Operational status of the interface.

1 2 ... 443 444 445 446 447 448 449 450 451 452 453 ... 602 603

Comentarios a estos manuales

Sin comentarios

APC IP DSLAM Guía de usuario Pagina 448

Comentarios a estos manuales

Relacionado con productos y manuales para Redes APC IP DSLAM