APC Network Management Card AP9617 Guía de usuario descargar pdf (Pagina 89)

®®

USER’S GUIDE

network management card

Control

Initiating a UPS Control option

You can initiate a UPS Control option in either of these ways:

• For the UPS of the initiating Management Card only.

– In the Web interface, select No for Apply to Sync Group?

– In the control console, type NO (in uppercase) in response to the

question Apply command to all SCG members?

• For all members of the Synchronized Control Group to which this

Management Card belongs (if the option is allowed for Synchronized

Control Groups).

– In the Web interface, select Yes for Apply to Sync Group?

– In the control console, press

ENTER in response to the question

Apply command to all SCG members?

The following guidelines apply to Synchronized Control Groups:

• All UPSs in a Synchronized Control Group must be the same model.

• Synchronized Control Groups are supported for most UPS models of

the Smart-UPS and Symmetra UPS product lines. Any Smart-UPS or

Symmetra UPS with a card slot that accepts a Network Management

Card supports Synchronized Control Groups.

• In a Synchronized Control Group of Symmetra 3-phase UPSs, the

shutdown mode setting must be either normal or secure for each UPS.

The option to apply an action to a Synchronized

Control Group is displayed only if this Management

Card is an active (enabled) member of a

Synchronized Control Group.

To configure a Management Card to be a member of a

Synchronized Control Group, see Sync Control.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 189 190

Sin comentarios

APC Network Management Card AP9617 Guía de usuario Pagina 89