APC INROOM ACPSC3000 Instrucciones de operaciones descargar pdf (Pagina 103)

103InRoom Controller - Operating Instructions

Telnet/SSH

You can access the control console through Telnet or Secure SHell (SSH), depending on which is enabled. (An

Administrator can enable these access methods in the Web interface by selecting the Administration tab, then

Network on the top menu bar, and the access option under the Console heading on the left navigation menu.)

By default, Telnet is enabled. Enabling SSH automatically disables Telnet.

Telnet for basic access. Telnet provides the basic security of authentication by user name and password, but not

the high-security beneﬁts of encryption. To use Telnet to access the Network Management Card control console

from any computer on the same network:

1. At a command prompt, use the following command line, and press

ENTER:

telnet address

As address, use the Network Management Card IP address (or DNS name, if conﬁgured).

2. Enter the user name and password (by default,

apc and apc for an Administrator, or device and apc

for a Device User).

SSH for high-security access. If you use the high security of SSL for the Web interface, use Secure SHell (SSH)

for access to the control console. SSH encrypts user names, passwords, and transmitted data.

The interface, user accounts, and user access rights are the same whether you access the control console through

SSH or Telnet, but to use SSH, you must ﬁrst conﬁgure SSH and have a SSH client program installed on your

computer.

See the User’s Guide for more information on conﬁguring and using SSH.

Note: The menu structure for administration and device management in the control console differs

from the menu structure for these areas in the Web interface. See the User‘s Guide for an overview

of the control console menus

1 2 ... 98 99 100 101 102 103 104 105 106

Sin comentarios

APC INROOM ACPSC3000 Instrucciones de operaciones Pagina 103